Handle bars:
-cut of unnesary length
put your hands to the closest part of the bars till the bend down to the stem. make shure its cumphy then cut off the remains leave about an inch
-drill holes
depending on if you run brakes. you can drill a hole large enough to run your cable through. on your avrage 2pc bars i drilled two holes in the center peace for no reason but also you can drill holes were your grips sit. like the micneil silencers. run the brake cable down the bottom where the stem holds it. drill a hole on the oposit side of the brake lever(in the stem area or the bars)make the hole face you. so it runs straght to the back. and giv it enough slack to were you can do all the barspins and what ever wiht out tension. sand of the eadges of the entrance and exit points of the cable to avoid any damage.
- run bar endless
- change your grip to the race grip stuff seen on race bikes
-if you want reg. grips cut of the donut at the end of the grip.
BRAKEs
-run a invisable hanging wire insted of standard metal strands. it saves agrivation with frilling. saves aliltle weight, and runs alot smoother just put alitle silicon lube be for you put it in the cable housing.
SEAT
-cut unused piping.
- use rail system or get the eclat complex seat w/ built in seat post at 6.4oz, and the cost of a seat post! alone
-buy hollow stem bolts, use them on your seat clamp! you can also use thoes for other things on your bike too!
-use holow stem bolts to replace crank bolts
TITANIUM
-use it!
Axle
-use shadow nuts not eastern. the easterns strip easer