Just get it and try it out. That's cheap for a cosmo

Cult coaster. Two drivers in three hours of riding is pretty poor form

You won't notice it at all

You won't notice that much of a change. Just remember that's .17 of and inch. It would be like swapping from thin pedals to some slightly thicker ones.

Get a marmoset and not have to worry anymore

A lot of my mates are running the colony coaster with no complaints. Unlike the blind and cult coasters

12 back and 4 up is perfect

I found the best way was to find what I wanted on danscomp, then go to empire and buy shit through a rider owned store that actually gives a fuck about the scene

Sounds like the clutch is slipping or something is wrong with the engagement. Pull it a part (take pictures as you do) and have s look and make sure everything is right inside the hub

Odyssey cable. I don't rate the éclat pads. Try the flys or the good old odyssey ones (not ghost pads)

Buy from empire

Tree ergo is the comfiest pivotal seat I've run. Other than that a fat/slim piv is pretty much the same no the brand

I haven't read any of the previous posts above me but have you tried swapping the spacers around on your brake pads? Or even adding an extra thin washer? I've had to do this in the past. As long the pads grab the rim at the same time you should be ok ... more »

Fronts for the win

5'10 8.6" 21" Shortest reach and tallest top load slammed to the h/t

Depends on what grounds you want Personally I've run: 9" bonedeths, bennyL's, custom standards, bob bars and odyssey 4x4's. All good bars but I prefer the bonedeths or the Benny's

I have run 30-9 for a couple of years and really liked it. Just recently dropped down to 28 and haven't noticed much difference to be honest. What it comes down to really is your frame clearance. Most modern frames won't clear 28 let alone 30

Try greasing the bolts can help tighten them right up and won't come loose due to vibration

No freecoasters are being released in 48. Only will be old stock of the old khe clones. Bonedeth have 48spoke hubs out cassette and fronts Profile also have them if you order off of their site.