10/28/19
Yeah for sure man, it's ***********
Plastic peg go kchunk chsssssss blop
can you do a dick flip
If you dont have any of the shims, you can also just file down the lip on the bottom of the dust cap until it stops rubbing. Its definitely either that or you tightened your headset too tight. The grease that you used for your headset wouldn't really ... more »
I dont think so. Pretty sure you're thinking of the shorty, which does have brake mounts but it has a different geo
Over the past few months I've replaced a lot of the parts on my bike (bars, stem, cranks, sprocket, hubs), so I figured I'd make a new bike check. I'm really stoked with how everything is. I'm finally at a point where there's nothing fucked up with it
This forum thread has 3 replies
Seriously such a nice build. Skapegoat's my dream frame
Outside
You're right, my bad. I looked at the specs of this model before I posted https://m.vitalbmx.com/product/guide/Bikes,6/United/Supreme,7893 Didn't realize you had the higher end one
Looks pretty solid to start out with. Definitely better than what I first started with. I'd say the first things you're probably gonna start running into problems with would be the bars, forks, and rims. The frame will probably hold up for a decent while, ... more »
I find sleep to be really important for that. If I sleep like shit, then I usually ride like shit
oh no you're totally fucked dude it's broken oh god
Since when was the word "affect" a synonym for kill?
Pant or perhap no pant
Looks like a 2009 shovelhead https://m.vitalbmx.com/product/guide/Bikes,6/Eastern/Shovelhead,944 Definitely worth $50. Assuming it doesn't have a bunch of problems, that'd be a perfect bike to start out on. But even if it does have problems, it's not ... more »
Depends, if you do a lot of crooks or crank arm grinds then you might have a problem with hitting your sprocket and chain. Also, if you're sloppy with your grinds then you're probably gonna want to get a guard sprocket, otherwise you might have problems ... more »
Make sure your cone nut isn't too tight on the driver. The bearings in that hub's driver tend to blow out pretty easily so be careful with how much you tighten that cone nut.
