Sundaybmxrr- I hope that's the case with some of my other pedals, as my first pair I attempted it on was *not* a double nut setup, it was merely a single nut at the end of a cromo spindle (there was a nut, a spacer and two sealed bearing cartridges) ... more »

It was the compression nut, for some reason it was moving when I tightened the wheel in....left it ~1/16th turn looser before re-tightening the axle nuts and all was well, am in love with this new driver I've ridden 2nd-hand drivers and wheels for so ... more »

I know I'm long-winded when I write so I'm guessing you didn't read my whole post but yeah it's a LHD driver lol, the pawls are catching beautifully (in fact I'm f'ing in love with the noise of them, mmmm fresh pawls bangin that hub w/ minimal grease ... more »

the one that goes around the outer-most edge of the driver, sealing it against the outer-most ring of of the outside of the hub-body? I had a black (seemed more plastic than rubber) thin washer/gasket there, honestly I don't even recall seeing it yesterday ... more »

Not bad for 400 grit, am excited to see where 1-2k grit gets me! I'm not sure how practical it is trying to match polished steel to chrome but hopefully it's enough to get a matching effect

LOVE them, like I don't know that I'll get a different grip for a looong time, I've tried a TON of different grips and was actually liking smoother stuff (cult DAKS for instance) but am in love with the hoders, I'll definitely be getting these for a

... more »

ROFL! I agree though, I've had my weight-weenie phases, I brought my 24lbs (from factory) united su2 down to a hair over 23lbs, ended up making some sacrifices for comfort or practicality and had it right back to 24lbs (for different reasons, and now ... more »

Exactly! I feel like I'd *constantly* be worried about it, wouldn't be worth the 2nd-guessing it would cause, am going to continue using mine!

That's what I was suspecting, gotcha

I dig the look of it, but wouldn't consider doing it if it made that area weaker and i really suspect it does to some degree even if not major. I was looking at your bike-check, that's a great bike man! ... more »

For some reason it looks like my original reply didn't go through, so apologies if this is a double-reply (and for the fact it will be shorter/blunter than my original, my dinner's ready tho lol) There's no reason to believe those are cheap forks, in ... more »

Yeah that last paragraph you write is what I've realized - but it requires me getting the parts of this geometry I like by buying both new frame (20.75) and like 25mm (shorter?) forks, and forks are stupid-expensive and frames usually are too, am unsure ... more »

I dunno what to do now, I hadn't tried barspins yet on this and did today, with the bars forward, and the shorter TT, the grip was in my legs I couldn't do anything (27.75" bars) Am looking for cheap, short-rake forks now but not having lots of luck, ... more »

Thanks man, it's *feeling* awesome!! I'm in love with this new geometry and am killing it with it, also just gotta love when everything's tight and perfect, I went over every last bit to tune/tighten/adjust in the days following the actual build, it

... more »