Started new thread Paint your pedals 12/9/2017 8:11 PM

Paint or use something to mark your pedals so you know what side is up and can clearly see it so when you grind or stall you only scrape the pins off of on side and the other side stays like new and will last much longer. I like to grind a lot, Here

... more »

This forum thread has 5 replies

Liked a comment on the item Stunt Bike 12/5/2017 6:38 PM

Really digging the purple

Added reply in a thread What'd you do to your bike today? 12/5/2017 6:37 PM

In my comment the word "bike" is a link to my bike check.

Added reply in a thread What'd you do to your bike today? 12/5/2017 5:13 PM

I just picked up my new Gsport rollcage and Merritt wheels from the shop and put em on my bike.

Added bike check Stunt Bike 12/5/2017 5:05 PM
C138_20171205_192757
Added reply in a thread Anyone go to joyride 150 11/1/2017 6:41 PM

Yes.

Added reply in a thread What size bars should I use? 9/26/2017 7:51 PM

You can cut them if they are too wide.

Added reply in a thread Who here has experienced CATASTROPHIC bike failure? 9/17/2017 4:13 PM

They were chromoly and I did not contact kink because I was already going to buy r25's, and that just sped up the process.

Added reply in a thread Who here has experienced CATASTROPHIC bike failure? 9/13/2017 4:27 PM

They were from a high end 2016 kink complete bike.

Added reply in a thread Who here has experienced CATASTROPHIC bike failure? 9/13/2017 4:08 PM

I tried to do a 15 foot bank to bank gap at my skate park. When I was in the air my bars went into my lap and I landed sitting on my back wheel. Snapped my forks and scratched my brand new

Added reply in a thread Tires. 4/27/2017 8:18 PM

I'm going to get the new Eclat mirage tires, they look pretty good and Ill save over 1 lb by switching from Merritt options. The options are great but they are heavy and I have slid out multiple times on wood (Joyride 150).

Added reply in a thread Cutting Bars 3/1/2017 2:04 PM

Ok thanks.

Added reply in a thread Cutting Bars 3/1/2017 1:55 PM

I have a pipe cutter. I'm just wondering how much i should cut off if any?

Started new thread Cutting Bars 3/1/2017 1:37 PM

I just got new bars (9" x 29") and i want to cut them down to help with learning bar spins as i have hit my knees with my old bars (8.25" x 29") while trying them. I tend to grab my bars on the inside of then grips. My frame is 21tt and I'm 6' if that ... more »

This forum thread has 9 replies

Started new thread Odyssey Thunderbolt vs Merritt Battle Cranks? 170 vs 175? 2/12/2017 7:40 PM

I am going to buy new cranks either the Odyssey Thunderbolt or the Merritt Battle cranks. I currently run 175mm cranks and am wondering if I should switch to 170mm.

This forum thread has 9 replies