Yeah well you are smarter than me, I was put out of riding from a injury manualing on ice

Manuals do get really tricky with the short chain stays

Snow doesn’t usually stop me but now that it’s 1 degree out side I’m ready for a break. We need to start a cheap bmx forum lol

I just miss wrote it it says right on the bike that it’s a 18.5 inch top tube

Yeah that’s my plan for it I think I may have some old brakes hanging around I could pull on to jump it

Ok I’ll keep that in mind

What is wrong with the Sunday and GT frame I know lots of people that love them

Yeah I would think about the legion really I’m looking at a Sunday primer or a GT performer, I’m not going to buy a free coaster hub but I am going to see if I could get my coaster break disabled with out hurting the hub as I already have to send it ... more »

Yeah I would but my buddy had it up for 50 for months and it didn’t sell I’ll probably just keep it in case I need a back up bike later down the road

It’s what I got I’m only 14 so I’m not made of money, this summer when there is a lot of farm work I’ll have the money for a new one

I’m converting it to a free coaster like my last bike was, I just haven’t done it yet but I do mostly flatland stuff and this is the first bmx bike I have had in a few years so I’m just trying to shake the cobwebs off.

Yeah, it’s having a problem with the rear hub but I’m taking it to the shop for adjustments. I like the bike and once I convert it to a free coaster it will work better for me. I’m planning on building a new bike as soon as work picks up but this bike ... more »

What I got right now and I don’t really have much money

I wish but I can see the hub moving and shifting, I talked to the shop and they are going to readjust it

So I took it to the bike shop to get a cone and hub adjustment done and it’s still got a lot of play in the rear tire

I’m putting loseball bearings that is what the right bearing is

Yeah u should ur In for a show

I’m not actually doing that I’m going to the bike shop this week to see if they have the right bearings

I can just give it to one of my buddy’s in the machine shop program at my high school