Drive side hub guards

And it comes so lose that my chain pops of my sprocket

Take a close up photo of how it's installed and post it here. Sounds like you have something tightening up against something else preventing the wheel from actually being tight. (That may not make a lot of sense but could be explained better if you provide a visual)

transition_chris wrote:

Take a close up photo of how it's installed and post it here. Sounds like you have something tightening up against something ...more

transition_chris wrote:

Take a close up photo of how it's installed and post it here. Sounds like you have something tightening up against something else preventing the wheel from actually being tight. (That may not make a lot of sense but could be explained better if you provide a visual)

...more

Ok brb

That's how I put it on then it gets real lose and my chain falls off

tighten each side a little at a time alternating sides. my modded fbm does the same thing

I've tried that

Mine works just fine

OneGuyIlluminatiEye wrote:

Mine works just fine

OneGuyIlluminatiEye wrote:

Mine works just fine

...more

Show pic of it on your bike

you should put the spacer on the inside of your peg bro. and make sure you have enough spacers inside the drop out, there shouldnt be any visible gap between the inside of the dropout and the lock nut on the hub. If there is that could be causing it.

Makes some sense ima try your idea

Did it have this problem before you installed the guard?



Also check to see if the guard is touching any of the frame's welds, that could cause it to sit uneven in the dropouts and shift easier.

Also check if your dropouts are bent at all, that could be contributing to it too

OneGuyIlluminatiEye wrote:

Mine works just fine

OneGuyIlluminatiEye wrote:

Mine works just fine

...more

Zxzbmxteam wrote:

Show pic of it on your bike

Zxzbmxteam wrote:

Show pic of it on your bike

...more

Is your wheel lined up

Zxzbmxteam wrote:

Is your wheel lined up

Zxzbmxteam wrote:

Is your wheel lined up

...more

For the most part yes and no due to my frame not being welded together correctly back there (thanks solid) but im sure it would sit it there wih no issues if i have a frame that was made right

I also have the infinity guard on the other side
definitely recommend it if you go 4 pegs

The drive side guard is pretty huge make sure its not resting on the welds of your frame thats the only down side of this hub guard