Gyro Setup???

Related:
Create New Tag

9/22/2016 7:48 PM

I have been wanting to upgrade my stock brakes and I figured I might as well get gyros. I already have gyro tabs on my bike, plus a few other cheap parts that I was wondering if I could/should reuse. I like the look of the Odyssey G3 Detangler at Dan's Comp - www.danscomp.com
https://www.danscomp.com/products/510003/Odyssey_G3_Detangler.html but I'm not 100% sure that it would work with my bike (it says in the description that it might not work with some integrated headsets). Also, would I have the get a new headset spacer? I have a solid 20mm shadow conspiracy one and I wasn't sure if I need to get a new one to run plates. Photo

Photo

|

“Pegless and coaster is ultimate zen”
-Indiana Tom

9/22/2016 7:49 PM

And no, I won't run brakeless haha. And yes, I know my bearing is popping out a little.

|

“Pegless and coaster is ultimate zen”
-Indiana Tom

9/23/2016 7:40 AM

you should be fine with the g3 set up

|

It’s all bmx

9/23/2016 7:46 AM

You may need a new headset spacer to accommodate the plate. Any bike shop will have a pack of them for a few quid though

|