Posts: 3
Joined: 10/18/2010
Location: Las Vegas, NV USA
I Just got Fly Bikes manual brakes today that I ordered from danscomp. There are rubber insert type things in the calibers where the mount goes in. Because of this, the mount does not fit. Should I take the rubber out? And the bolt that tightens the springs is no where close to long enough to reaching the frame. How do I install these??? I have the Fit Van Homan Signature. I need my brakes back!! Please help if you can! Thank you.
Posts: 7
Joined: 10/23/2012
Location: Fort Lauderdale, FL USA
Posts: 5390
Joined: 12/14/2010
Location: TX, USA
Pics would help.
100+REFS
I'm on the Vital legit list.
Terrible One!
Mutiny Loosefer.
Tumblr.
PSN- timm-377
Posts: 3
Joined: 10/18/2010
Location: Las Vegas, NV USA
I tried looking on google and nothing came up. I had to use my old mount bolts, but they work now. Thanks for the replies! Much appreciated!
Posts: 8
Joined: 7/2/2009
Location: Wellington Tawa, NZL
only just seen this but yes those rubber things come out they are just to protect the inside and fit frames use one long bolt to hold both the mount and the caliper on so you have to use the original long bolt that comes with the frame
