Posts: 15
Joined: 10/14/2013
Location: VIR
I installed a 23.75mm x 19mm x 6mm sprocket adapter onto my sprocket and I first tried it out without the sprocket bolt and it was turning fine with no wobbles at all. However when I screw in the sprocket bolt, one end of the sprocket adapter comes out of the sprocket causing it to wobble. Why is that happening? Did I buy a sprocket adapter with the wrong thickness?
Posts: 4290
Joined: 7/31/2010
Location: TN, USA
I think at this point you need to start posting pics of what you're working with, maybe even some video.
22-Inch BMX
@22inchbmx on Instagram
Paragon Custom 22" Pedal Driven Cycles
Posts: 15
Joined: 10/14/2013
Location: VIR
Here are some pics.
sprocket adapter installed
sprocket adapter installed (underneath)
sprocket adapter becomes loose after sprocket bolt is in
sprocket adapter becomes loose after sprocket bolt is in (different angle)
Posts: 15
Joined: 10/14/2013
Location: VIR
Edited Date/Time:
I was thinking... If I bought a Profile Crank Spider that can be used on 19mm spindles would that mean I won't have to use an adapter anymore?
Posts: 7417
Joined: 7/15/2013
Location: Saint Louis, MO USA
Appears that the adapter is too long. You can grind it down and eliminate the problem. Basically, you don't want the adapter to hang out of the sprocket hole, it should sit flush or even be thinner than the sprocket.
Refs : SnM An1mal, GThompson121, Chuck8273, blizzbikes, bmxsteve99, kevin.brock.338, zinum, Brian_Griffin, billyhandyjunior, riverM, tomdon
Instagram : @timhankinsbmx
Posts: 15
Joined: 10/14/2013
Location: VIR
Edited Date/Time:
I see. Is there any other alternative to grinding it down, such as using a spacer between the sprocket bolt and sprocket? Will that work as well?
Posts: 7417
Joined: 7/15/2013
Location: Saint Louis, MO USA
That would hold your sprocket crooked and mess with your chain alignment. Grind it down until its ALMOST as thick as your sprocket. Just a little bit thinner.
Refs : SnM An1mal, GThompson121, Chuck8273, blizzbikes, bmxsteve99, kevin.brock.338, zinum, Brian_Griffin, billyhandyjunior, riverM, tomdon
Instagram : @timhankinsbmx
Posts: 15
Joined: 10/14/2013
Location: VIR
Posts: 4875
Joined: 6/29/2012
Location: Elk Grove, CA USA
SkywayBMXer wrote:
Okay I'll do that. Thanks for the advice.
No, no, no! Use a 22mm spacer. Put it on top of the 19mm adapter and it should go right over it, and take the space up between the adapter and sprocket.
Latest Bike Check/Update
Bought from: adam1234, tomdon (2), oscarbmx, the balt, smokesmokesmoke
Posts: 15
Joined: 10/14/2013
Location: VIR
