Posts: 5085
Joined: 3/14/2013
Location: Richmond, VA USA
I need to get my drive side bolt off my rear hub. Only the non drive side will come off. It's an ezra opus hub with the trans axle. I need to get it figured out so i can take my bike on vacation on sunday. The bolt will only move a very little and when it does it's spinning the axle.
I love my bike but i hate myself
bike check
IG
@curtis_cantbmxwell
@powersbikeshop
Posts: 21431
Joined: 5/23/2008
Location: Royalton, MN USA
Moderator
Tighten the non drive side down, THEN try to loosen the drive side.
"Hey anybody ever make that mistake like right when you wake up in the morning and you believe in yourself?" -Kyle Kinane
"BIKES!" -Tom Segura
Posts: 5085
Joined: 3/14/2013
Location: Richmond, VA USA
dave lawrence wrote:Tighten the non drive side down, THEN try to loosen the drive side.
I'd already done this. My neighbor came over and used the same tool as me, turning the same direction, and it came loose like nothing. My bike hates me.
I love my bike but i hate myself
bike check
IG
@curtis_cantbmxwell
@powersbikeshop
Posts: 7842
Joined: 7/15/2013
Location: Saint Louis, MO USA
Tighten the living fuck out of your non driveside, loosen your drive side, loosen your non driveside, in that order.
Is there an allen key broach in your center axle? That could help alot.
Soak that bitch in oil and keep trying.
Refs : SnM An1mal, GThompson121, Chuck8273, blizzbikes, bmxsteve99, kevin.brock.338, zinum, Brian_Griffin, billyhandyjunior, riverM, tomdon
Instagram : @timhankinsbmx
