Posts: 3034
Joined: 3/8/2012
Location: water, GBR
my mate just got his, and we cant get it on right, weve taken the cone nut off, but it hits the spokes so weve tried various spacer combinations and still no luck :/ it always ends up stiff when you roll the wheel. I'm nota retard with bikes, but im really confused on this one. The hub he's got is a stock one of a wethepeople zodiac 2011
NEW Bike check
That InstaGram ting - @EddiMundo
Raw Clips Edit
KriB Life YouTube channel (Click on the pic!)
Posts: 3673
Joined: 5/26/2012
Location: Coronado, CA USA
hit has to be a press fit hub. the guard only fits press fit. if there are bolts on the side that tighten and loosen the hub then it wont work. it has to be like a remix or raptor or somthing like that.
Old bike VVV
California Living
I now have a more or less stock sunday scout with a complete Demo rear wheel. Sue me
Posts: 12
Joined: 1/23/2013
Location: Melbourne, AUS
Slide a few washers onto the axle first and then put on the guard so it pushes against the bearing of the hub.
Posts: 909
Joined: 1/31/2012
Location: Fort Lauderdale, FL USA
I had asme prob with the spokes, I gave up lol
i used to like pork till i found out it came from cops...
Posts: 3034
Joined: 3/8/2012
Location: water, GBR
cheers guys.I already tried with some spacers against the bearing, didnt work :L its not press fit so that must be it :/ its right, he can just send it back
NEW Bike check
That InstaGram ting - @EddiMundo
Raw Clips Edit
KriB Life YouTube channel (Click on the pic!)
