Posts: 13
Joined: 1/25/2013
Location: Caldwell, NJ USA
"Take a look at me now, I'm from the gutta but I made it, I made it to the top of the world,
Nothin holdin me down, I told them haters I would make it, I made it to the top of the world"
Posts: 922
Joined: 3/17/2013
Location: Billings, MT USA
if its a sticker ive heard use gas and a flame
Save a tree
Ride a Bike...... I am an environmentalist jk hahaha
BIKE CHECK: http://www.vitalbmx.com/community/WallmartBMX,103987/setup,83842
WATCH MY NEW EDIT IM SO PROUD OF IT!!
Posts: 5711
Joined: 8/27/2011
Location: Columbus, OH USA
Looks to be under the clearcoat.
YOU AVIN A LAUGH M8?
┬┴┬┴┤ ( ͡° ͜ʖ├┬┴┬┴
The Trailest Bike On Vital
Posts: 10
Joined: 12/7/2012
Location: Circle Pines, MN USA
you can get stickers off without leaving stick shit by using a hair dryer and just blow on it with the hair dryer ( obviously on warm ) for like 5 minutes and peel them off while still aplying heat.
Posts: 223
Joined: 6/7/2013
Location: Forestville, CA USA
Use a heat gun or a hair dryer and heat it up, then peel it.
Why be the same when you can be different?
Official Vital Buddy: Chrisaustin
Posts: 6
Joined: 6/27/2013
Location: Belchertown, MA USA
Not sure if this will help, but on my stolen sinner there was these stickers that would flake off rather than peel off, and i tried all the tricks, and heat guns would just make it really messy, but i ended up taking a peice of polished metal that had an edge that wasn't really sharp and used it to scratch off the stickers, left a little sticker resin but it worked
